Chapter 7: Accessories
7-11
Screw A
Mounting bracket
Screws B
Should you wish to fit a narrow cut sheet feeder onto a wide print-
er, you will have to fit the mounting bracket for the wide roller as
described below. You will need a cross-head screwdriver for this
purpose.
Adjusting the moun-
ting bracket
1. Undo and remove screw (A)
on the inside of the output
tray.
2. Turn the cut sheet feeder
over and place it on a steady,
level surface. The two
screws (B) are now accessi-
ble.
3. Undo and remove the screws (B) at both ends of the mounting
bracket.
4. Carefully remove both parts of the mounting bracket from the
cut sheet feeder.
5. Move the left bracket rail ap-
proximately 5 mm to the left.
Align the fixing hole precise-
ly to the pin and the thread-
ed hole on the cut sheet feed-
er and screw the left screw
(B) in again.
To Next Page
Loading...
