Oki ML1120 - Page 69

ML1120/ML1190 eco User’s Guide – Operating instructions > 69
Symbol Sets
Menu
Slashed Letter
0
Set whether to
convert slashed 0
located at 9BH and
9DH in USA code
page or not.
Yes
No
Rear Feed
Menu
Line Spacing Select line feed
pitch.
6 LPI
8 LPI
Form Tear-Off Select manual or
auto as the method
to advance a
continuous form to
the form tear-off
position.
Manual
500 ms
1 sec
2 sec
Skip Over
Perforation
Select whether to
skip over
perforation or not.
(When a skip over
perforation setup
command is
received, the
received command
is given priority.
Yes (25.4 mm/ 1 in)
No
Cut Position
Adjust
Select an
adjustment value
for the position to
cut the end of a
continuous form.
(In 1/180 in
increments)
-20 - -1
0
+20 - +1
TOF
Adjustment
(continuous)
Select an
adjustment value
for the reference
position in regard to
the TOF position of
a continuous form.
The position moves
to the rear of the
form by [+] and to
the top of the form
by [-] in 1/180
increments.
-20 - -1
0
+20 - +1
MENU ITEM FUNTION SETTING