Page: 107
Service Guide ML520/521
Chapter 3 Maintenance & Disassembly
3.3.07 Tear Feature
NOTE:
Tear is activated by pressing TEAR. It is a manual procedure.
FORMS TEAR OFF is activated by changing a setting in the Menu. It is an automatic procedure.
General Information
This feature allows a printed page (rear or bottom feed, continuous form) to be torn off without wasting
paper or adjusting the printer.
Tear Feature advances the paper from the initial printing position to the tear off position. The top of the
page (perforation) will be even with the tear bar. The tear bar is located under the clear top of the access
cover.
Paper will remain in the tear off position until the printer receives data. Then, the paper is retracted to the
initial print position.
To activate the Tear Feature, press TEAR.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
To Next Page
Loading...
Need help?
General
