OKPOS Optimus - LCD Customer Display

Installation
|
Installing Optional Devices 17
4.
Connect the RJ-45 cable of the VFD to the COM3 port.
5.
Replace the I/O port cover by following the instructions in “Replacing the I/O port cover“ on
page 12.
6.
After installing the VFD, change the BIOS setting by following the instructions in “Setting Up the
VFD“ on page 44.
Removing the VFD
You can remove the VFD by following the steps in the installation procedure in reverse order.
LCD Customer Display
Installing the LCD Customer Display
To assemble the LCD customer display, follow these steps:
1.
Remove the I/O port cover by following the instructions in “Removing the I/O port cover“ on
page 10.