Need help?Do you have a question about the Oldham iTrans and is the answer not in the manual?
General| Brand | Oldham |
|---|---|
| Model | iTrans |
| Category | Measuring Instruments |
| Language | English |
Technical specifications of the iTrans gas monitor, including dimensions, power, and output signals.
Details certifications and standards the iTrans™ gas monitor complies with, including CSA and UL.
Specific safety instructions for using the iTrans™ in the EU, focusing on flameproof requirements.
Provides important factors to consider before installing the iTrans™ gas monitor, such as location and environmental conditions.
Covers alarm relay, power/output, and sensor wiring for the iTrans™ unit.
Explains ModBus wiring, setting addresses on the unit, and setting addresses for stand-alone sensors.
Details how the iTrans™ displays gas readings, alarm indications, and fault indicators in normal operation.
Covers sensor type, zeroing, calibration, span gas, and span reserve using a magnetic wand.
Details programming functions via buttons, including channel selection, alarms, time setting, and zero/calibration.
Details the procedure for replacing a sensor, emphasizing that it must be done by qualified personnel.
Provides a table listing common symptoms, their potential problems, and solutions for the iTrans™ gas monitor.
Outlines the warranty periods for iTrans™ fixed system products, sensors, and infrared sensors.
To Next Page
