50
Changing the remote control code...
If the fax machine is connected to a secondary telephone
operating in tone dialling and set for manual reception
or for automatic reception with recognition of the call
type, whenever a remote party calls to send a document,
you can control its reception by entering the code * * on
the same secondary telephone. This operation is similar to
pressing the START key on your fax.
You can replace the second asterisk of this code with
a digit from 0 to 9.
If your fax model without answering machine is
connected to an external answering machine, you
should use a digit different from the one used for the
remote control of the answering machine.
Procedure DISPLAY
1
Make sure that the
display shows the initial
waiting mode with date
and time.
MANUAL RX
30-03-99 12:55
2
Press the FUNCTION
key until the display
shows --->.
INSTALLATION
3
Press the START key. TEL.LINE SET-UP
4
Press the START key. PUB.LINE (PSTN)
5
Press the START key
until the display shows
--->.
REMOTE START: ON
With the </> keys, you can show the other option
available: "REMOTE START: OFF".
6
Press the
START
key. TYPE CODE
CODE (0/9, *) **
7
Enter the new code,
e.g.: "*8".
TYPE CODE
CODE (0/9, *) *8
8
Press the
START
key
to confirm the entered
data, then the STOP
key to restore the fax to
the initial waiting mode.
MANUAL RX
30-03-99 12:55
If you are connected to a private line, follow the same
procedure but after step 4, press the > key to show
the option "PRIV.LINE (PBX)".
OTHER USEFUL TRANSMISSION
SETTINGS...
Setting automatic resolution...
If you have not selected the resolution before transmit-
ting or copying a document, the fax machine will auto-
matically transmit or copy based on the preset value (in
this case: STANDARD).
You can set the fax machine to transmit or copy auto-
matically with FINE resolution using the following pro-
cedure:
Procedure DISPLAY
1
Make sure that the
display shows the initial
waiting mode with date
and time.
AUTOMATIC RX
22-03-99 12:15
2
Press the
FUNCTION
key until this appears
on the display --->
FAX SET-UP
3
Press the START key. DATE AND TIME
4
Press the
FUNCTION
key.
VARIOUS SETTINGS
5
Press the START key
until this appears on
the display --->
TX RESOL. STD
6
Press the </> keys to
see the other values
available "TX RESOL.
FINE".
TX RESOL. FINE
7
Press the START key
to confirm your choice
then the STOP key to
return the fax machine
to the initial waiting
mode.
AUTOMATIC RX
22-03-99 12:15
-7-46-54.p65 02/04/01, 9.2350
To Next Page
