65
Message: “MEMORY FULL”
One or more documents received in the memory, due to
an anomaly during reception, have filled up the memory:
check the type of anomaly (no paper or jammed paper,
no ink, cover open, etc.) and remove it. The documents
will automatically be printed, clearing the memory.
Message: “NOT PROGRAMMED”
You have chosen a one-touch dial key or a speed-dial-
ling code that you had not programmed: program the
key or the code (see “Programming one-touch dial
and speed dialling”, under the “For everyday use”
chapter).
Message: “OUT OF INK”
The ink in the cartridge has run out: replace the print
head if it is of the disposable type or replace the car-
tridge if it is replaceable (see “Replacing the print
head” or “Replacing the ink cartridge”).
Message: “PAPER ERROR, PRESS ”
The paper jammed while copying or receiving a docu-
ment: press the STOP key and, if the sheet is not ejected
automatically, check where it jammed and remove it (see
“Removing jammed documents and sheets”).
Message: “POLL. RETRY nnn”
You have set a reception polling and the connection
could not be established because of errors on the line
or because the receiver was engaged: the fax machine
is waiting to carry out the automatic redialling attempts.
Message: “REMOVE DOCUMENT”, “PRESS “
•
A document jammed while copying or transmitting:
press the STOP key and, if the document is not ejected
automatically, remove it manually (see “Removing
jammed documents and sheets”).
•
You interrupted the document scanning operation by
pressing the STOP key.
Message: “RX ERROR”
Reception was not completed correctly: press the STOP
key to turn off the “ERROR” indicator light and to clear
the message from the display.
Message: “RX IN MEMORY”
Reception continues in memory because an anomaly took
place while receiving a document, which could not be
printed: check, on the lower line of the display, the type of
anomaly, and remove it.
Message: “SYSTEM ERROR nn”
An anomaly which blocked the fax machine has oc-
curred: switch the fax machine off and on again. If the
error persists, switch the fax off and call the technical
support service.
Message: “TX ERROR”
Transmission was not completed correctly: press the STOP
key to turn off the “ERROR” indicator light and to clear
the message from the display, then repeat the transmis-
sion.
Message: “WRONG CODE, PRESS ”
• The answering machine access code is incorrect:
press the STOP key and re-insert the correct code.
-8-55-66.p65 02/04/01, 9.2365
To Next Page
Loading...
