Olympus 27MG - 4 Initial Setup; Table 4 Default Conditions

DMTA-10043-01EN, Rev. C, July 2016
Initial Setup 31
4. Initial Setup
This chapter demonstrates basic 27MG setup techniques. The unit is shipped from the
factory, setup with the default conditions provided in Table 4 on page 31.
These conditions have been selected to demonstrate the instrument’s ease of use.
Further explanation of these default conditions can be found in later sections of this
manual. These conditions may be changed after the operator becomes familiar with
the advanced features of the gage.
Table 4 Default conditions
Condition Comment
Standard
resolution
0.01 mm (0.001 in.)
Sound
velocity
5.740 mm/µs (0.2260 in./µs).
(Approximate sound velocity for
the carbon steel test bar provided
with the gage.) See note below.
Blank
mode
Display is blank when not making
a measurement.