Connecting the Camera to a
Computer
Connecting to a Windows PC
If you are using a computer installed with the Windows 98/98SE
operating system, install the USB driver during operation using the
included software CD.
1 Make sure the camera’s power
is off.
2 Open the camera’s connector
cover.
3 Insert the end of the USB
cable marked “A” into the
USB connector on the
computer.
4 Insert the end of the USB
cable marked “B” into the
USB connector on the
camera.
• The green lamp next to the
viewfinder will be illuminated if
the camera is connected to the
computer correctly.
122
To Next Page
Loading...
