2 Installation and connection
2-1 Installation
BU100RS
Caution
(for installation and connection)
Be sure to mount the UPS into the bottom shelf of a rack.
● There is a risk of injury if the product falls.
● This product is a heavy object. If it is mounted into the top part of the rack and falls,
it may cause damage to other equipment.
To mount into a rack, tighten the screws well so that there is no gap
between the ear brackets of the product and the rack.
● A gap may cause the product to fall.
To mount or remove, do not apply load to the product such as pulling a
cable.
● Applying load may cause the product to fall.
Notes
Periodically check that the screws are not loose and that there is no gap
between metal sheets.
● A loose screw may cause damage to the product.
If mounting the UPS with both front and rear mount rails, use a 19" rack
support angle mounting bracket set (BAP100RS).
● For details about how to mount UPS, refer to the instruction manual for
BAP100RS.
To Next Page
Loading...
