112
3-1 Settings
3-1-1 Cable Connections
• Connect the power supply cable of the Analog Output Unit to the power supply
connector of the Analog Power Supply Unit and secure the power supply cable
connector with screws.
• The CQM1-IPS02 incorporates two power supply connectors. The power sup-
ply cable of the Analog Output Unit can be connected to either one of the power
supply connectors.
• Refer to the CQM1H Operation Manual (W363) or the CQM1 Operation Manu-
al (W226) for details on connecting an Analog Output Unit and Analog Power
Supply Unit.
Note Do not pull the power supply cable, or the power supply cable may be broken or
connector may be disconnected.
3-1-2 Wiring
Voltage Output
Analog Output Unit Terminals
Current Output
Analog Output Unit Terminals
Settings Section 3-1
To Next Page
Loading...
