Omron CQM1H series - Operation Mode B Read

211
Parameter
Zero shift value storage area
0: Unchanged
1: RAM (factory-set)
2: Nonvolatile memory
Number of mean value processings
0: Unchanged
1: 1
2: 2
3: 4 (factory-set)
4: 8
5: 16
Input sampling speed
0: Unchanged
1: Fast
2: Slow (factory-set)
Response
If the correct command code or parameter is set to the output word, the com-
mand code or parameter is set to the input word as a response.
If the wrong command code or parameter is set to the output word, one of the
following error codes will be set to the input word.
E000: This error code will be set to the input word if a nonexisting command code
is used.
E001: This error code will be set to the input word if the parameter is not within
the range covered by the Unit.
7-3-4 Operation Mode B Read
This command is used to read the data that has been input in operation mode B.
Command
Command Code
Parameter Parameters are not used with this command.
Commands and Responses
Section 7-3