Omron CQM1H series - List of Commands; Commands and Responses; Operation Mode a Set

208
Note The Linear Sensor Interface Unit acknowledges the start or end of a command
through a change in the output word value. When “0000” is set to the parameter
by the setting command, for example, even if “0000” is set at the end of the com-
mand, the command doesn’t end because there is no change in the output word
value, not allowing scaled conversion data or comparison result to be set in the
input word. To end the command, set a value other than the one set to the param-
eter. However, that the value will be reflected on the monitor output if the Unit is
used in the set data D/A output mode. Therefore, when using the Unit in the set
data D/A output mode, be sure to select a value which will not affect peripheral
devices.
7-2 List of Commands
The following commands can be used to set the initial parameters through the
Programming Console.
Command Command
code
Meaning Reference
page
Operation mode A set C000 Used to set operation mode A. 208
Operation mode A read C100 Used to read the settings of operation mode A. 209
Operation mode B set C200 Used to set operation mode B. 210
Operation mode B read C300 Used to read the settings of operation mode B. 211
Scaling value set C4** Used to set a scaling value. 212
Scaling value teach C5*0 Used to execute scaling value teaching. 213
Scaling value read C6*0 Used to read a scaling value. 213
Set value set C7** Used to set a set value. 214
Set value teach C8*0 Used to execute the set value teaching. 214
Set value read C9*0 Used to read a set value. 215
Hysteresis set CA00 Used to set hysteresis. 215
Hysteresis read CB00 Used to read the hysteresis. 216
Present value read CC00 Used to read the present scaled conversion data. 216
7-3 Commands and Responses
7-3-1 Operation Mode A Set
This command is used to set the following operation mode data.
• Data input
• Timing hold
• Input type
• Monitor output
The above items will be stored in the nonvolatile memory and will not be lost after
the Unit is turned OFF.
Command
Command Code
Commands and Responses
Section 7-3