Omron CQM1H series - Comparison

194
7. When the Unit correctly receives the command, the input word will be set to
2000.
CHG
C
2
A
0
A
0
A
0
WRITE
c100 c001
2000 2000
CHG
SHIFT
C
2
C
E
4
C
2
A
0
WRITE
c100 c001
C420 C420
8. Set 0000 for the Y1 value and 1000 for the Y2 value using the above method.
CHG
A
0
A
0
A
0
A
0
WRITE
c100 c001
0000 0000
CHG
SHIFT
C
2
C
E
4
D
3
A
0
WRITE
c100 c001
C430 C430
CHG
B
1
A
0
A
0
A
0
WRITE
c100 c001
1000 1000
9. After setting all the scaling values, reset 0000 to the output word. After the
scaling operation, 0534 will be set to the input word.
CHG
A
0
A
0
A
0
A
0
WRITE
c100 c001
0000 0534
5-5 Comparison
The comparison function is effective only when the timing hold in operation
mode A is set to normal.
The setting methods of the set values and hysteresis to compare the present
scaled conversion data and the set values are explained below.
The preset set values and hysteresis are effective only when the Unit is set to
comparison mode. The hysteresis is, however, available only if the timing hold is
set to normal. Use the operation mode A set command to change the timing
hold.
Refer to 6-2 Set Value Teaching for the method to obtain the set values from the
teaching operation.
Settings Set the LL, L, H, and HH set values so that these set values are within a range
from –9999 to 9999. The following are the factory-set set values.
LL and L: –9999
H and HH: 9999
Therefore, if the Unit is operated with the factory-set set values, the PASS bit of
the input word will be always ON.
Set the hysteresis to a value between 0001 and 0999 for the LL, L, H, and HH set
values. The factory-set value of the hysteresis is 0001.
Comparison
Section 5-5