170
1-1 Features
• When the Linear Sensor Interface Unit is used in a system, linear sensor input
signals received by the Unit are converted into appropriate numeric values ac-
cording to preset scaling values.
• The Linear Sensor Interface Unit compares the scaled conversion data with
the four comparison set values (HH, H, L, and LL), ensuring the ease of object
discrimination.
• The four timing hold modes that are synchronized with the external signal input
allow free setting of the input data sampling point and easy retrieval or control
of desired data.
• The CQM1-LSE02 can convert input data into voltage output, which can be
used as data for external monitoring.
• The teaching function enables the Linear Sensor Interface Unit to use actual
input as scaling and comparison set values, thus ensuring the easy adjust-
ment.
• The zero point (measurement standard point) can be forced, which allows rel-
ative object measurement.
• A ladder program can be used to enable the CQM1-LSE02 to have voltage out-
put. The ladder program used with the CQM1-LSE02 enables the output volt-
age to correspond to the data.
• The Programming Console can be used to easily set the Linear Sensor Inter-
face Unit to its initial values.
Model Type
CQM1-LSE01 Standard
CQM1-LSE02 With monitor output
1-2 System Configuration
Power Supply CQM1H/CQM1-series
CPU
Linear Sensor
Interface
Other Units
Sensor input
(V INPUT/I INPUT)
Timing input
(T/G)
Monitor output
(OUTPUT)
• Use the Programming Console to write its initial values to the Unit.
Linear Sensor Interface
Units
System Configuration
Section 1-2
To Next Page
Loading...
