Omron CQM1H series - Page 147

127
1-3-2 Remote Console
Use the mode setting selector of the dedicated CQM1-TU001 Remote Console
for the CQM1-SEN01 to set sensor modules mounted to the CQM1-SEN01 to
operation monitor mode or teaching mode.
1-3-3 Sensor Modules
The following dedicated sensor modules can be mounted to the CQM1-SEN01.
Name Model
Optical Fiber Photoelectric Module E3X-MA11
Photoelectric Module E3C-MA11
Proximity Sensor Module E2C-MA11
Dummy Module E39-M11
Note Mount the E39-M11 Dummy Module to any unused slot of the CQM1-SEN01 for
dust prevention.
1-3-4 Applicable Sensors
The following sensors can be used with the E3X-MA11 Optical Fiber Photoelec-
tric Module.
Sensing method Model
Thru-beam E32-T11L, E32-TC200, and E32-T11
Side view thru-beam E32-T14L
Heat-resistive thru-beam E32-T51
Screen thru-beam E32-T16
Reflective E32-D11L, E32-DC200, and E32-D11
Side view reflective E32-D14L
Heat-resistive reflective E32-D51
Retroreflective E32-R21
Note The E3X-MA11 can be used with a variety of sensors in addition to those listed
above. The E3X-MA11, however, cannot be used with the E32-DC9G,
E32-DC9G4, E32-D61, or E32-D73.
The following sensors can be used with the E3C-MA11 Photoelectric Module.
Sensing method Model
Thru-beam E3C-S10, E3C-1, and E3C-2
Diffuse reflective E3C-DS5W, E3C-DS10
Convergent reflective E3C-LS3R
Mark detection reflective E3C-VS1G, E3C-VS3R, E3C-VM35R,
and E3C-VS7R
The following sensors can be used with the E2C-MA11 Proximity Sensor Module.
• E2C-CR5B
• E2C-CR8A
• E2C-CR8B
• E2C-X1A
• E2C-C1A
• E2C-X1R5A
Connecting Devices
Section 1-3