IX
● Special markings
(1) Important
This appears in cases where incorrect settings or operation will prevent a
function from achieving the expected result.
(2) Hint
This gives useful hints, advice, and other supplemental information.
(3) Marks used to indicate "Function," "Setting," "Monitor," and "Reference" in "Setting
Data" in Section 8 are explained in Section 8.
● Abbreviations
Abbreviations used in the setting data, illustrations, and text are as follows.
* Data after scaling is shown in industrial units such as °C, m, and g, and "EU" is
used to indicate the minimum increment of such a quantity. For example, the
minimum increment of 50.02 m is 0.01 m, and thus 1 EU would be equal to 0.01 m.
● Notation used for settings
Letters, numbers and abbreviations in settings that appear in the E5AR/ER display
are as follows.
Set the input type before setting the scaling value.
If the input type is changed after setting the scaling value, the scal-
ing value will be automatically initialized.
The rise and fall values of the SP ramp of the E5AR/ER can be set
separately.
Important
Hint
Abbreviation Meaning
PV Present value
SP Set point
SV Set value
AT Auto-tuning (A.T)
EU Unit of industrial quantity*
ch Channel
abcdefghijklm
ABCDEFGH I JKLM
nopqrstuvwxyz
NOPQRSTUVWXY Z
0123456789 -1
0123456789-1 (Most signif-
icant digit)
To Next Page
Loading...
Need help?
General
