8.3 Operation level ( )
8-11
Setting data
• Use this to run or stop control.
• The initial setting is "Run".
Press the UD keys to select "run: Run" or "stop: Stop". When
"Stop" is selected, the "STOP" indicator lights up.
● Related information
"4.12 Starting and stopping control" (P.4-27)
● Related setting data
"PF1 setting", "PF2 setting" (Advanced function setting level)
(P.8-68)
• Use to select Auto or Manual.
• The initial setting is "auto".
Press the UD keys to select "auto: Auto" for Auto mode, or "manu:
Manual" for Manual mode. When Manual mode is selected, the
"MANU" indicator lights up.
• This setting does not appear if either "PF1 setting" or "PF2 setting"
is set to Auto/Manual. "PF1 setting" is initially set to Auto/Manual to
enable use of the A key, and thus the setting does not appear.
● Related information
"4.13 Performing manual control" (P.4-29)
● Related setting data
"PF1 setting", "PF2 setting" (Advanced setting level) (P.8-68)
Run/Stop
r-s
CH
Function
Operation
Reference
Reference
Auto/Manual
a-m
"PF1 setting" ≠ Auto/Manual
and
"PF2 setting"
≠ Auto/Manual
CH
Function
Operation
Reference
Reference
To Next Page
Loading...
