Omron E5AR - MANUAL 2 User Manual

Section 8 Setting data
8-28
Setting data
Use this setting to store alarm values for alarms 1 to 4 in each bank.
• Set the values of alarms 1 to 4 in each of banks 0 to 7.
This setting can be used when the alarm type is other than "none",
"Upper- and lower-limit alarm", "Upper- and lower-limit range alarm",
or "Upper- and lower-limit alarm with standby sequence".
● Related setting data
"Alarm
∗ type" (Alarm setting level) (P.8-54)
"Alarm
∗ latch" (Alarm setting level) (P.8-55)
"Alarm
∗ hysteresis" (Alarm setting level) (P.8-56)
"Standby sequence restart" (Alarm setting level) (P.8-57)
"Auxiliary output
∗ non-exciting" (Alarm setting level)(P.8-58)
Bank
∗ alarm 1
Bank
∗ alarm 2
Bank
∗ alarm 3
Bank
∗ alarm 4
(
∗: 0 to 7)
∗ .al-1
∗ .al-2
∗ .al-3
∗ .al-4
Alarm function is enabled
CH
l.bnk
Function
Setting
Setting range Units Default value
-19999 to 99999 EU 0
Reference
Reference

Omron E5AR - MANUAL 2 Specifications

General

Brand	Omron
Model	E5AR - MANUAL 2
Category	Controller
Language	English