Omron E5AR - MANUAL 2

Section 8 Setting data
8-44
Setting data
The setting range is 0 to 1 on a single- or 4-input type, or 0 to 6 on a 2-
input type.
● Related information
"Section 3 Typical Control Examples" (P. 3-1)
"4.6 Selecting the control mode" (P.4-13)
● Related setting data
"Manual reset value" (Adjustment level) (P.8-15)
"Hysteresis (heat)", "Hysteresis (cool)" (Adjustment level) (P.8-16)
"Control/Transfer output
∗ assignment" (Control initial setting 2 level)
(P.8-46)
• When direct action is selected, the MV is increased when the PV
increases. When reverse action is selected, the MV is increased
when the PV decreases.
● Related information
"4.7 Setting output parameters ■ Direct operation (cool) / Reverse
operation (heat)" (P.4-14)
• Use this setting to select the control method for a position propor-
tional type.
● Related information
"3.3 Position proportional control of a ceramic kiln" (P.3-9)
Setting
Setting range Units Default value
0: Standard
1: Heating/cooling
2: Remote SP standard
3: Remote SP heating/cooling
4: Proportional
5: Cascade standard
6: Cascade heating/cooling
− 0
Reference
Reference
Forward/reverse operation
orev
CH
l.1
Function
Setting
Setting range Units Default value
or-r: Reverse operation
or-d: Direct operation
− or-r: Reverse action
Reference
Reference
Closed/Floating
clfl
Position proportional type
CH
l.1
Function
Setting
Setting range Units Default value
float: Floating
close: Closed
− float: Floating
Reference
Reference