Omron G9SP Series

5
Function Block Editing Section 1-2
1-2 Function Block Editing
Function blocks can be edited to set parameters, add optional I/O, and add
comments for the application. The displayed tabs and contents of the settings
depend on the function block.
1-2-1 Parameters
The following parameters can be set for function blocks depending on the
user application. The parameters that can be set will vary from function block
to function block.
• Reset condition
• Input type
• Discrepancy time
Refer to SECTION 3 Descriptions of Function Blocks for information on the
parameters for each function block.
1-2-2 Setting the Number of I/O Points and Output Point Settings
Setting the Number of I/O Points
The number of inputs and the number of outputs for a function block can be
increased.
Output Point Settings
Optional outputs from function blocks can be enabled.
Tabs:
• Function block parameters
• Settings of the number of I/O points and output point settings.
• Comments