To Next Page

To Previous Page

2-7SectionTouch Switches

138

The window is changed to the frame display only as follows, with the

mark at the center of it:

Window moving key

move

3. Press the touch panel of the PT at the moving destination.

Window is moved so that the center position of the window comes to the

pressed position.

This time, Display Position of the corresponding window area is changed.

Press the moving destination

move

When the window is in a moving status (while mark is displayed at the center

of the window), the following points differ from the normal running status.

• The elements that use the touch panel as an input do not function regard-

less of the screens (base/window) they are registered on. Only the specifi-

cation of the window moving destination is possible.

• Switching to the system menu is not possible.

• Screen switching or window controlling due to the change in bit memory

table entry, PT status control area or window control area is not possible.

• Screen saver function does not work.

• There is no time-limit for a window moving status. It will not return to the

normal running status until the moving destination is specified.

Reference:  Window moves by a minimum touch switch size (2020).

 Be sure to complete all the window moving operation when in the window mov-

ing status, since its behavior differs from the one when in the normal running

status.

Screen Print Key Function (NT31/NT31C and NT631/NT631C Only)

This function allows starting and stopping of the printing of a hard copy of the

currently displayed screen (screen image) at a printer connected to the PT. (This

function is not supported by the NT21.)

Reference:  The PT continues operating during printing.

 The printer type and printing method (color/monochrome (8 gray-scale levels))

is determined by memory switch setting at the PT.

 A hard copy of the screen can also be printed by operation with the PT status

control bits. In this case also, printing can be stopped part way through by

pressing a touch switch.

Omron NT21 User Manual

Other manuals for Omron NT21