9 Setting Up Slave Terminals
9 - 34
NX-series EtherCAT Coupler Unit User’s Manual (W519)
9-4 Transferring and Comparing Settings
This section describes how to transfer and compare EtherCAT Slave Terminal settings that you set on
the Sysmac Studio.
This section describes how to transfer Slave Terminal settings and I/O allocation settings to the Control-
ler.
On the Sysmac Studio that is connected to an NJ-series CPU Unit, use the synchronization function of
the Sysmac Studio to transfer all of the following data: network configuration information, configuration
information, Unit operation settings, and Unit application data.
The actual operating procedure is given below.
1 Place the Sysmac Studio online with the CPU Unit and execute synchronization.
The comparison results are displayed in the Synchronization Pane.
WARNING
Always confirm safety at the destination node before you transfer Unit configuration
information, parameters, settings, or other data from tools such as the Sysmac Studio.
The devices or machines may operate unexpectedly, regardless of the operating mode
of the Controller.
9-4-1 Transferring Settings
Procedure to Transfer Settings
To Next Page
Loading...
Need help?
General
