Omron NX-ECC201 - Resetting Errors; Introduction; Details on Resetting Errors

11 - 27
11 EtherCAT Coupler Unit Functions
NX-series EtherCAT Coupler Unit User’s Manual (W519)
11-9 Resetting Errors
11
11-9-1 Introduction
11-9 Resetting Errors
This section describes how to reset errors that occur in the EtherCAT Slave Terminal.
The error reset function is used to change the error status of a target EtherCAT Slave Terminal to a nor-
mal state.
Refer to 13-4 Resetting Errors on page 13-40 for the error reset methods.
The following table describes how to reset errors in the EtherCAT Slave Terminal from the Sysmac Stu-
dio, and gives the range of errors that you can reset.
Additional Information
You can use an NS-Series PT to reset errors for the entire Controller.
11-9-1 Introduction
11-9-2 Details on Resetting Errors
Error Reset Methods
Methods and Specified Range for Resetting Errors
Sysmac Studio connection Batch reset Individual reset
Peripheral USB port or built-in Ether-
Net/IP port on NJ-series CPU Unit
Resets all error in the Controller.
This includes resetting errors in
the EtherCAT Slave Terminal.
Resets errors in the specified
Unit.
Peripheral USB port on EtherCAT Cou-
pler Unit
Resets all errors in the EtherCAT
Slave Terminal.