Omron NX-ECC201 User Manual

Unit Versions
28
NX-series EtherCAT Coupler Unit User’s Manual (W519)
• Hardware version
• Software version
The software version is displayed only for Units that contain software.
The functions that are supported depend on the unit version of the Unit. The version of Sysmac Studio
that supports the functions that were added for an upgrade is also required to use those functions.
Refer to A-7 Version Information on page A-59 for the functions that are supported by each unit version.
In this User’s Manual, unit versions are specified as shown in the following table.
Unit Versions and Sysmac Studio Versions
Unit Version Notation
Unit version in Unit specifications
on the product
Notation in this manual Remarks
Unit version 1.0 or later Ver. 1. or later Unless unit versions are specified, the infor-
mation in this manual applies to all unit ver-
sions.

Omron NX-ECC201 Specifications

General

Brand	Omron
Model	NX-ECC201
Category	Controller
Language	English