General
Status
Code (hex)
Status Name Description of Status
16 Object does not exist An object that does not exist was specified for the requested serv-
ice.
17 Service fragmentation se-
quence not in progress
The fragmentation sequence for this service is not currently active
for this data.
18 No stored attribute data The attribute data of this object was not saved prior to the requested
service.
19 Store operation failure The attribute data of this object was not saved due to a failure dur-
ing the attempt.
1A Routing failure (request
packet too large)
The service request packet was too large for transmission on a net-
work in the path to the destination. The routing device was forced to
abort the service.
1B Routing failure (response
packet too large)
The service response packet was too large for transmission on a
network in the path from the destination. The routing device was
forced to abort the service.
1C Missing attribute list entry
data
The service did not supply an attribute in a list of attributes that was
needed by the service to perform the requested behavior
.
1D Invalid attribute value list
The service is returning the list of attributes supplied with status in-
formation for those attributes that were invalid.
1E Embedded service error An embedded service resulted in an error.
1F Vendor specific error A vendor-specific error occurred. The Additional Code Field of the
error response defines the error
. This is a general error code that is
used only for errors that do not correspond to any of the error codes
in this table and are not in an object class definition.
20 Invalid parameter A parameter for the requested service is invalid. This code is used
when a parameter does not meet the requirements of the specifica-
tion and/or the requirements defined in an application object specifi-
cation.
21 W
rite-once value or medi-
um already written
An attempt was made to write to a write-once medium (e.g. WORM
drive or PROM) that was previously written or cannot be changed.
22 Invalid Reply Received An invalid reply was received. (For example, the reply service code
does not match the request service code, or the reply message is
shorter than the minimum expected reply size.) This status code is
used for other causes of invalid replies.
23 Buffer Overflow The message received is larger than the receiving buffer can han-
dle. The entire message was discarded.
24 Message Format Error The format of the received message is not supported by the server.
25 Key Failure in path The key segment that was included as the first segment in the path
does not match the destination module. The object specific status
must indicate which part of the key check failed.
26 Path Size Invalid The size of the path that was sent with the service request is either
too large or too small for the request to be routed to an object.
27 Unexpected attribute in list An attempt was made to set an attribute that is not able to be set at
this time.
28 Invalid Member ID The member ID specified in the request does not exist in the speci-
fied class, instance, and attribute.
29 Member not settable A request to modify a non-modifiable member was received.
2 A Group 2 only server gen-
eral failure
This error code is reported only by group 2 only servers with 4K or
less of code space and only in place of Service not supported, At-
tribute not supported, or Attribute not settable.
Appendices
A - 82
NX-series Safety Control Unit User's Manual (Z930)
To Next Page
Loading...
Need help?
General
