7
Safety Precautions
G5-series AC Servomotors and Servo Drives User’s Manual (with Built-in EtherCAT Communications)
Use the Servomotor and Servo Drive in a specified combination.
Fire or equipment damage may result.
Do not store or install the Servo Drive in the following locations:
•Location subject to direct sunlight
•Location where the ambient temperature exceeds the specified level
•Location where the relative humidity exceeds the specified level
•Location subject to condensation due to rapid temperature changes
•Location subject to corrosive or flammable gases
•Location subject to high levels of dust, salt content, or iron dust
•Location subject to splashes of water, oil, chemicals, etc.
•Location where the Servo Drive may receive vibration or impact directly
Installing or storing the Servo Drive in any of these locations may result in fire, electric
shock, or equipment damage.
The Servo Drive radiator, Regeneration Resistor, Servomotor, etc., may become hot while
the power is supplied or remain hot for a while even after the power supply is cut off. Never
touch these components.
A burn injury may result.
Storage and Transportation
When transporting the Servo Drive, do not hold it by the cables or Servomotor shaft.
Injury or failure may result.
Do not overload the Servo Drive or Servomotor. (Follow the instructions on the product
label.)
Injury or failure may result.
Use the Servomotor eye-bolts only when transporting the Servomotor.
Do not use them to transport the machine.
Injury or failure may result.
When lifting a 15 kW or higher Servo Drive during moving or installation, always have two
people lift the product by grasping a metal part. Do not grasp a plastic part.
Risk of injury or product damage.
Caution
Caution
To Next Page
Loading...
