3 Specifications
3-16
G5-series AC Servomotors and Servo Drives User’s Manual (with Built-in EtherCAT Communications)
z Terminal Block Specifications, Top Terminal Block (TB1)
z Terminal Block Specifications, Bottom Terminal Block (TB2)
Precautions for Correct UsePrecautions for Correct Use
• Tighten the terminal block screws to the torque of 1.5 N·m (M5) or 2.5 N·m (M6).
• If the torque for terminal block screws exceeds 2.0 N·m (M5) or 3.0 N·m (M6), the terminal
block may be damaged.
• Tighten the fixing screw of the terminal block cover to the torque of 0.4 N·m (M5).
• Tighten the ground screw to a torque of 2.4 to 2.6 N·m (M6).
• Do not connect any External Regeneration Resistors between B1 and NC.
R88D-KN150F-ECT
Symbol Name Function
24 V Control circuit power
supply input
24 VDC ±15%
0 V
DB1 Dynamic Brake Resistor
control terminals
These terminals are used to control the MC for externally connected
dynamic brake resistance. The output contact specifications are 1 A max. at
300 VAC/100 VDC max.
Connect them if required.
DB2
Symbol Name Function
L1 Main circuit power
supply input
R88D-KNF-ECT (15 kW):
3-phase 380 to 480 VAC (323 to 528 VAC) 50/60 Hz
L2
L3
B1 External Regeneration
Resistor connection
terminals
Connect an External Regeneration Resistor between B1 and B2.
B2
NC Do not connect.
U Motor connection
terminals
Red These are the output terminals to the Servomotor.
Be sure to wire them correctly.
VWhite
WBlue
Green/
Yellow
Frame ground This is the ground terminal. Ground to 10 Ω or less.
To Next Page
Loading...
