Omron ZN-A Series - Page 34

24
Section 2 UPGRADING THE SYSTEM
ZN
System Manual
Section 2
Setup Methods Suited to Specific Applications
9. Press the ENT key.
This sets the specified target value.
Setting the low power air volume level
10. Display [LWIND] on the main display.
11. Set the low power air volume level of
the Air Clean Unit.
Set the air volume level within 1 to 5 (default
value: 1).
Set a limit value for the air volume beyond which
air is not to be fed.
12. Press the ENT key.
This sets the specified air volume level.
13. Set the mode switch to RUN.
This starts feedback control operation.
When the setting is next used, feedback is automatically started simply by turning the Air
Clean Unit power supply ON.
2sysup.fm24ページ２００７年６月２８日 木曜日 午前９時１７分