EasyManua.ls Logo

OneScreen HL7 - Placement; Power Supply

OneScreen HL7
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
OneScreen
HL7
2.2 Placement
• Do not put heavy objects on top of the unit
• Do not put the unit near appliances that generate magnetic elds
• Do not expose the unit to direct sunlight and other sources of heat
• Do not place the unit on an unstable cart, stand, tripod, bracket, table, or shelf
• Do not place the device upside down or throw it during transportation and storage
• Do not tilt or scratch the device during installation
• Do not expose the device to water
• Do not place the device in direct path of the air conditioner or heater
• Do not place or use the display in an environment with volatile, corrosive, or combustible chemicals
• Do not clean the device with water or chemical solutions
• Always use electrical accessories certied by the device manufacturer
• Make sure that the display and its auxiliaries are reliably grounded prior to use
• Cut o the power supply and contact OneScreen Support upon discovery of any abnormality, including
any unusual smell, smoke, power leakage, or abnormal temperature
2.3 Power Supply
• Connect the device to a 100-240V AC power supply
• Please avoid any physical damage to the power cable
• Please check and ensure AC source is connected with the ground
• Please unplug power supply during thunderstorm or lightning
CAUTION Indicates a potentially hazardous situation that, if not
avoided, could result in equipment damage, data loss,
performance deterioration, or unanticipated results
WARNING Indicates a hazard with risk that, if not avoided, could result
in death or injury