Onkyo A-9030 Owner's Manual

18
En
With u (Remote Interactive), you can use the following
special functions:
■ Auto Power On
When you start playback on a component connected via
u while the integrated amplifier is on Standby, the
integrated amplifier will automatically turn on and
select that component as the input source.
■ Direct Change
When playback is started on a component connected via
u, the integrated amplifier automatically selects that
component as the input source.
■ System Off
When you turn off the integrated amplifier, the
components turn off automatically.
■ Remote Control
You can use the integrated amplifier’s remote controller
to control your other u-capable Onkyo Components,
pointing the remote controller at the integrated
amplifier’s remote control sensor instead of the
component.
To operate the CD player, point the remote controller at
the CD player.
Tip
• For details on operating the connected components, see “Remote
Controller” (➔ page 11).
Note
•Use only u cables for u connections. u cables are supplied
with your Onkyo CD Player, Tuner or u Dock.
•If two u jacks are present, you can use either one indifferently
as they work the same way.
• Connect only an Onkyo CD Player, Tuner or u Dock to the u
jack. Connecting other manufacturer’s components may cause a
malfunction.
• Only Onkyo CD Players, Tuners, and u Docks are supported
by the integrated amplifier’s u. With other components such
as MD recorders, the u won’t work properly.
• Some components may not support all u functions. Refer to
the manuals supplied with your Onkyo CD Players, Tuner or u
Docks.
• The CD Players only support the Auto Power On and Direct
Change functions.
Connecting Onkyo u Components
1
Make sure that each Onkyo CD Player, Tuner or
u Dock is connected and that the RI MODE switch
is set correctly (➔ pages 15 to 17).
Caution
• Settings will not be enabled even when the selector is
changed in the Standby mode.
• To change a setting, be sure to turn on the unit prior to
making any changes.
2
Make the u connections (see the illustration).
Digital Media Transport,
u Dock
Tuner or CD Player
Integrated Amplifier

Onkyo A-9030 Specifications

General

Damping factor	60
Amplifier class	A/B
Frequency range	10 - 100000 Hz
Output impedance	8 Ω
Audio output channels	2.0 channels
Peak power per channel	- W
Signal-to-Noise Ratio (SNR)	105 dB
Total Harmonic Distortion (THD)	0.08 %
RMS power output per channel (1 Ohm)	65 W
Audio (L/R) in	5
Audio (L/R) out	1
Speakers connectivity type	Clamp terminals
Purpose	Home
Material	Aluminium, Metal
Product color	Silver
Volume control	Rotary
Bass adjustment	Yes
Connectivity technology	Wired
Built-in display	No
AC input voltage	220-230 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.3 W
Power consumption (typical)	135 W
Package weight	9400 g

Weight and Dimensions

Depth	330.3 mm
Width	435 mm
Height	139 mm
Weight	7400 g