Onkyo A-9030 Owner's Manual

25
En
Advanced Operations
Custom Setup
When the Auto Standby (ASb) function is activated, the
integrated amplifier will automatically enter Standby
mode if there is no operation for 30 minutes with no audio
signal input.
You can set the impedance of the speakers that you
connect to the unit. (A-9050 only)
Caution
• Settings will not be enabled even when the selector is changed in
the Standby mode.
To change a setting, be sure to turn on the unit prior to making
any changes.
Setting the Auto Standby Function
1
Switch the AUTO STANDBY selector on the unit’s
rear panel.
` [ON]
Enables auto standby.
` [OFF]
Disables auto standby.
AUTO STANDBY selector
Setting the speaker impedance
1
Switch the SPEAKER IMPEDANCE selector on
the unit’s rear panel.
` [4 Ω or more and less than 8 Ω]
Sets the impedance to 4 Ω.
` [8 Ω or more and 16 Ω or less]
Sets the impedance to 8 Ω.
SPEAKER IMPEDANCE selector

Onkyo A-9030 Specifications

General

Damping factor	60
Amplifier class	A/B
Frequency range	10 - 100000 Hz
Output impedance	8 Ω
Audio output channels	2.0 channels
Peak power per channel	- W
Signal-to-Noise Ratio (SNR)	105 dB
Total Harmonic Distortion (THD)	0.08 %
RMS power output per channel (1 Ohm)	65 W
Audio (L/R) in	5
Audio (L/R) out	1
Speakers connectivity type	Clamp terminals
Purpose	Home
Material	Aluminium, Metal
Product color	Silver
Volume control	Rotary
Bass adjustment	Yes
Connectivity technology	Wired
Built-in display	No
AC input voltage	220-230 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.3 W
Power consumption (typical)	135 W
Package weight	9400 g

Weight and Dimensions

Depth	330.3 mm
Width	435 mm
Height	139 mm
Weight	7400 g