Onkyo A-9030 Owner's Manual

24
En
You can adjust the bass, treble and left/right output
balance respectively.
■ Operating on the integrated amplifier
Tip
• By default, bass, treble and balance is set to the center position.
Note
• While the Direct function is enabled, bass and treble are
disabled.
You can temporarily mute the output of the integrated
amplifier.
Note
• While the integrated amplifier is muted:
– Adjusting the volume or setting the integrated amplifier to
Standby will unmute the integrated amplifier.
Note
• Always turn down the volume before connecting your
headphones.
• When headphones are connected, the SPEAKERS button
cannot be used.
Adjusting the Bass, Treble and Balance
1
Turn the BASS –/+, TREBLE –/+ and BALANCE
L/R knobs.
BASS –/+ TREBLE –/+ BALANCE L/R
Muting the Sound
1
Press MUTING.
The SPEAKERS (A/B) and SELECTOR LEDs blink.
To unmute the integrated amplifier, press MUTING
again.
Using Headphones
1
Connect a pair of stereo headphones with a
standard plug (1/4 inch or 6.3 mm) to the PHONES
jack.
When connecting the headphones, the SPEAKERS
(A/B) LEDs go off.
You can adjust the volume and mute the sound, by
using VOLUME q/w.
While headphones are connected, no sound is output
from the speakers and PRE OUT jacks.
MUTING
PHONES jack

Onkyo A-9030 Specifications

General

Damping factor	60
Amplifier class	A/B
Frequency range	10 - 100000 Hz
Output impedance	8 Ω
Audio output channels	2.0 channels
Peak power per channel	- W
Signal-to-Noise Ratio (SNR)	105 dB
Total Harmonic Distortion (THD)	0.08 %
RMS power output per channel (1 Ohm)	65 W
Audio (L/R) in	5
Audio (L/R) out	1
Speakers connectivity type	Clamp terminals
Purpose	Home
Material	Aluminium, Metal
Product color	Silver
Volume control	Rotary
Bass adjustment	Yes
Connectivity technology	Wired
Built-in display	No
AC input voltage	220-230 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.3 W
Power consumption (typical)	135 W
Package weight	9400 g

Weight and Dimensions

Depth	330.3 mm
Width	435 mm
Height	139 mm
Weight	7400 g