Electric system
INFORMATION Risk of equipment malfunction!
• Never connect a USB device to the medical device while
it is in use.
• Use only USB pendrives that are free from viruses.
• The Medical Device is set to be used with a line
voltage of 100 - 240 V (± 10%), 50-60Hz. Check that
the local line voltage matches this voltage.
• Always replace the fuse with one of the same type.
• To reduce the risk of electric shock, do not remove the
protective cover. To replace the fuses, contact an
authorized technical service.
• Connect the R-EVO SMART to a mains power supply with
the features shown on the rear panel of the console. To
ensure safe operation, the medical device must have
adequate grounding.
• To avoid the risk of electric shock, the device must only
be connected to a power supply with adequate
grounding.
• Before connecting or disconnecting the unit to the
mains, ensure that the main switch is turned off.
• The main switch must be turned off when the device is
not in use.
• Before replacing the fuses, switch the device off and
let it cool down for a few minutes.
• If required by law and guidelines of the country in
which you are using, the Medical Device must be
connected to a UPS.
• Do not place containers containing liquids on the
Medical Device. Make sure that no cleaning products
are allowed into the device.
• Never try to connect electrical connectors by forcing
them (plugs, sockets). If a connector does not fit easily
into a socket, make sure it is not intended for another
socket. If a connector is damaged, contact your local
OPTIKON 2000 S.p.A. technical service.
• Do not use electric extension cords or multiple plugs.
• The systems must be grounded correctly to ensure safe
To Next Page
Loading...
