OPTIKON R-Evo Smart E - INSTALLATION PROCEDURE; Installation of the equipment

R-evo Smart E/S/CR Installation and use manual
Cod. 1X10XXEN 2020-09-14 Rev.E
57
4.3 INSTALLATION PROCEDURE
4.3.1 Installation of the equipment
The unit has been packaged in such a way as to
minimize the risk of damage during transport.
• Open the packaging and examine the components for
damage. When cutting the packaging material, be
careful not to damage the contents.
The R-Evo Smart E REF 111009 (S 111010) (CR 121012) consists of the following
parts:
Code
DESCRIPTION
111009
111010
121012
Console R-Evo Smart E; or
R-Evo Smart S Console; or
Console R-Evo Smart CR
Protective cover
1X10XXU0
Instructions for multilingual use.
IEC60601 safety test report (attached to the manual)
2 3.1AHT fuses
554138
Network cable
374578
Compressed air supply hose (CR and S only)
112105
Multi-function pedal
Optional cart:
REF
DESCRIPTION
181006
CART
181006U
Operation manual Bottle lifter trolley
CAUTION Risk of injury caused by damage during transport
• If the packaging or contents are damaged,
immediately notify the carrier (post office, railway or
shipping agent) and the OPTIKON 2000 S.p.A.
technical service.
• Check that the contents correspond to what is
indicated in the enclosed shipping documents.
Immediately notify the OPTIKON 2000 S.p.A.
technical service of any discrepancy.
To install the Medical Device, proceed as follows:
It is essential to receive appropriate training for the
correct installation and operation of the R-EVO SMART