OPTIKON R-Evo Smart E - EMC TABLES

R-evo Smart E/S/CR Installation and use manual
Cod. 1X10XXEN 2020-09-14 Rev.E
31
3.7 EMC TABLES
ELECTROMAGNETIC EMISSIONS
The emissions of this device make it suitable for use in industrial areas
and hospitals (CISPR 11 Class A). If used in a residential environment
(for which CISPR 11 Class B is normally required) this device may not
provide adequate protection for radio-frequency communication
services. The user may need to have means for mitigation, such as
repositioning or redirecting the device.
GUIDANCE AND MANUFACTURER’S DECLARATION – ELECTROMAGNETIC EMISSION
The R-Evo Smart systems are intended for use in the electromagnetic environments
specified below. The customer or the user of the R-Evo Smart must ensure that it is
used in such an environment.
Emissions testing
Compliance
Level
Electromagnetic environment
RF emissions
CISPR 11
Group 1
The R-Evo Smart Medical Device uses RF energy
only for its internal function. Hence the RF
emissions are very low and are not likely to
cause any interference with electronic devices
located nearby.
RF emissions
CISPR 11
Class A
The R-Evo Smart Medical Device is suitable for
use in all the establishments other than
domestic and directly connected to the public
low-voltage power supply network that supplies
buildings used for residential purposes.
Harmonic Emissions
IEC 61000-3-2
Not
applicable
Voltage fluctuations /
oscillating emissions
IEC 61000-3-3
Not
applicable