Optimum OPTimill MB 4 - Authorized Persons; Obligations of the Operating Company

Version 1.1.1 - 2021-1-25 11Translation of original instruction
MB4 EN
MB4_GB_1.fm
Qualified electrician
With professional training, knowledge and experience as well as knowledge of respective
standards and regulations, qualified electricians are able to perform work on the electrical sys-
tem and recognise and avoid any possible dangers.
Qualified electricians have been specially trained for the working environment, in which they are
working and know the relevant standards and regulations.
Qualified personnel
Due to their professional training, knowledge and experience as well as knowledge of relevant
regulations, qualified personnel are able to perform the assigned tasks and to independently
recognise and avoid any possible dangers.
Instructed person
Instructed persons were instructed by the operating company regarding the assigned tasks and
any possible risks of improper behaviour.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
 be duly qualified,
 and strictly follow these operating instructions.
In the event of improper use
 there may be a risk to personnel,
 there may be a risk of damage to the drilling- milling machine and other material values,
 the correct function of the drilling- milling machine may be affected.
1.6.2 Authorized persons
WARNING!
Inappropriate operation and maintenance of the milling machine constitutes a danger to
the personnel, objects and the environment.
Only authorized personnel may operate the milling machine !
Authorized operating and maintenance personnel are specialists instructed and trained by the
operator and the manufacturer.
1.6.3 Obligations of the operating company
The operator must instruct personnel at least once a year in
 all safety regulations relevant to the machine,
 its operation and
 generally accepted engineering standards.
The operator must also
 check the personnel‘s knowledge level,
 document the training/instruction,
 have attendance at the training/instruction confirmed by signature and
 check whether personnel is working in a manner that shows awareness of safety and risks.
 Define and document the machine inspection deadlines in accordance with section 3 of the
Factory Safety Order and perform an operational risk analysis in accordance with section 6
of the Safety at Work Act.