Version 1.1.1 - 2021-1-2516 Translation of original instruction
MB4
EN
MB4_GB_1.fm
Use the specified personal protective equipment. Ensure you wear close-fitting clothing
and, if necessary, a hairnet.
Do not use protective gloves when drilling or milling.
Disconnect the shock-proof plug from the outlet before replacing the tool.
Use appropriate agents to remove drilling and milling chips.
Ensure that your work does not create a safety risk.
Safely and firmly clamp the workpiece in place, before switching the drilling- milling machine
on.
We provide information about the specific dangers when working with and on the drilling- milling
machine in the descriptions for these types of work.
1.13 Switching-off and securing the drilling- milling machine
Disconnect the mains plug before starting maintenance and repairs.
1.14 Using lifting equipment
WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death.
Check that the lifting and load suspension equipment are of sufficient load-bearing
capability and are in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other supervisory authorities applicable to your company.
Fasten the loads properly.
Never walk under suspended loads!
1.15 Positions of the symbols on the drilling- milling machine
Make sure that the mandatory and warning symbols are legible.
Img.1-5: Symbols on MB4
1.16 Electronics
Have the machine and/or the electric equipment checked regularly. Immediately eliminate all
defects such as loose connections, defective wires, etc.
A second person must be present during work on live components to disconnect the power in
the event of an emergency. If there is a fault in the power supply, switch off the milling machine
immediately!
To Next Page
Loading...
