Optimum OPTimill MB 4 - Machine Use and Hazards

Version 1.1.1 - 2021-1-258 Translation of original instruction
MB4
EN
MB4_GB_1.fm
1.3 Intended use
WARNING!
In the event of improper use of the drilling- milling machine
 will endanger personnel,
 the drilling- milling machine and other material property of the operating company
will be endangered,
 the correct function of the drilling- milling machine may be affected.
The drilling- milling machine is designed and manufactured to be used for milling and drilling
cold metals or other non-flammable materials or materials that do not constitute a health hazard
by using commercial milling and drilling tools.
The drilling- milling machine must only be installed and operated in a dry and well-ventilated
place.
If the drilling- milling machine is used in any way other than described above, modified without
the approval of the company Optimum Maschinen Germany GmbH then the CNC machine is
being used improperly.
We will not be held liable for any damages resulting from any operation which is not in accord-
ance with the intended use.
We explicitly point out that any construction, technical or process engineering changes that
have not been approved by Optimum Maschinen Germany GmbH will render the warranty null
and void It is also part of the intended use that you
 observe the limits of the drilling- milling machine,
 the operating manual is observed,
 the inspection and maintenance instructions are observed.
 Technical specification on page 18
WARNING!
Severe injuries due to non-intended use.
It is forbidden to make any modifications or alternations to the operation values of the
drilling- milling. They could endanger the personnel and cause damage to the drilling-
milling machine.
1.4 Reasonably foreseeable misuses
Any use other than that specified under "Intended use" or any use beyond that described will be
deemed non-intended use and is not permissible.
Any other use must be discussed with the manufacturer.
It is only allowed to process metal, cold and non-inflammable materials with the drilling- milling
machine.
In order to avoid misuse, it is necessary to read and understand the operating instructions
before first commissioning.
Operators must be qualified.