Version 1.1.1 - 2021-1-25 35Translation of original instruction
MB4 EN
MB4_GB_5.fm
5.2 Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
Interval Where? What? How?
Start of work,
after every
maintenance
or repair work
Drilling- milling machine
Safety check on page 14
Start of work,
after every
maintenance
or repair work
Dovetail guides
Oiling
Oil all guide rails.
Every week
Milling table
Oiling
Oil all bare steel surfaces. Use an acid-free oil, e.g.
weapon oil or motor oil.
Weekly
Gear of milling head
Oil level
Check the oil level of the gear. The oil level must be in the
middle of the sight glass.
Abb.5-1: Oil sight glass speed gear
To Next Page
Loading...
