Version 1.1.1 - 2021-1-25 15Translation of original instruction
MB4 EN
MB4_GB_1.fm
1.11 Personal protective equipment
For certain work, personal protective equipment is required.
Protect your face and your eyes: Wear a safety helmet with facial protection when performing
work where your face and eyes are exposed to hazards.
Wear protective gloves when handling pieces with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the required personal protective equipment is available at
the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness. It must be
cleaned after each use and at least once a week.
1.12 For your own safety during operation
WARNING!
Before activating the drilling- milling machine, ensure that this will not endanger other
persons or cause damage to equipment.
Avoid any unsafe work methods:
Make sure that your operation does not create a safety hazard.
The rules specified in these operating instructions must be observed during assembly,
operation, maintenance and repair.
Use protective glasses!
Switch off the drilling- milling machine before measuring the workpiece.
Do not work on the drilling- milling machine, if your concentration is reduced, for example,
because you are taking medication.
Stay on the drilling- milling machine until the working spindle has come to a complete stand-
still.
General check
Equipment Check OK
Guards Mounted, firmly bolted and not damaged
Signs,
Markers
Installed and legible
Functional check
Equipment Check OK
Emergency switching off
push button
After the emergency switching off push button is pressed, the drilling-
milling machine must switch off. It must only be possible to restart the
machine, if the emergency switching off push button is unlocked and the
ON switch has been pressed.
Separation guard around the
drill and milling spindle
The drilling- milling machine may switch on only when the guard is
closed.
To Next Page
Loading...
