Electrical Safety Precautions
To protect yourself from harm and the Acme Packet 6300/6350 from damage, follow
the electrical safety precautions listed in the following subsections.
Precautions
• Note the locations of the power supply switches on the Acme Packet 6300/6350.
• Note the location of the emergency power-off switch for the room where the Acme
Packet 6300/6350 is located.
• If an electrical accident occurs, remove power from the system immediately by
unplugging the chassis.
• Always disconnect the power from the system when removing a Acme Packet
6300/6350 from its rack.
• When disconnecting power:
– Disconnect the circuit breaker at the rack.
– Unplug or unscrew the power cords from the power supplies.
• Use grounded AC power cords that are plugged into grounded electrical outlets.
• Never use extension cords to power a Acme Packet 6300/6350.
• Ensure that the installation facilities have proper grounding systems and include a
grounded rack structure or local grounding bus bar.
• When installing the Acme Packet 6300/6350 in an equipment rack, always make
the ground connection first and disconnect it last upon uninstallation.
• Use shielded Category 5e or 6, RJ45 cables for all 10/100/1000 Ethernet
connections to protect the Acme Packet 6300/6350 from potential damage.
• To avoid making a complete circuit (which causes electrical shock), use only one
hand when working with powered-on electrical equipment.
• Use caution when using electrically conductive tools around the Acme Packet
6300/6350.
• Remove jewelry before working on the Acme Packet 6300/6350.
Battery Warning
Note:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE. DISPOSE OF USED BATTERY ACCORDING TO THE
INSTRUCTIONS.
Perchlorate Material — Special handling may apply. See www.dtsc.ca.gov/
hazardouswaste/perchlorate.
Chapter 1
Electrical Safety Precautions
1-2
To Next Page
Loading...
Need help?
General
