RETURN
Pressing the Enter button for the RETURN selection returns you to the base display
during normal operating conditions or to the alarm display during an alarm condition.
Graphic Display Output for HA Nodes
The information included in this section only applies to high availability Acme Packet
6300/6350 System nodes. The graphic display on an Acme Packet 6300/6350 in an
HA node indicates the current HA state. Five state indications can be displayed on the
graphic display. Only the Standby and Active state indications appear in the graphic
display for more than a few seconds. An explanation and example of each HA state
follows.
Initial State Displays
The following example shows the output in the graphic display window of a Acme
Packet 6300/6350 in the initial state:
NET - NET
SESSION DIRECTOR (I)
Out Of Service State Displays
The following example shows the output in the graphic display window of an out-of-
service Acme Packet 6300/6350:
NET - NET
SESSION DIRECTOR (O/S)
Becoming Standby State Displays
The following example shows the output in the graphic display window of an Acme
Packet 6300/6350 going into standby mode:
NET - NET
SESSION DIRECTOR (B/S)
Standby State Displays
The following example shows the output in the graphic display window of a standby
Acme Packet 6300/6350:
NET - NET
SESSION DIRECTOR (S)
Chapter 3
Graphic Display Output for HA Nodes
3-7
To Next Page
Need help?
General
