• In Superuser mode, type set-system-state offline and press Enter.
ACMEPACKET# set-system-state offline
Setting system state to going-offline, process will complete when
all current calls have completed
ACMEPACKET#
Shutting Down the Acme Packet 6300/6350 Console
To shut down the Acme Packet 6300/6350 hardware:
1. Exit the ACLI and close your console or network connection.
2. Unplug the AC power cords from the power supplies on the rear panel of the Acme
Packet 6300/6350.
3. Confirm that the graphic display is dark and all fans are off.
Dark Graphic Display When Acme Packet 6300/6350 is Shut Down
Rebooting, Resetting, and Power Cycling
Reboot
Rebooting the Acme Packet 6300/6350 shuts down the system in an orderly fashion
and then starts it up again. The operating system gracefully shuts down as processes
are terminated and the file system is stopped. While the system and its processes are
stopped, all call processing is immediately halted. You may therefore wish to perform
tasks that call for a reboot during off-peak maintenance hours.
Rebooting the Acme Packet 6300/6350 is required every time you upgrade with a new
version of the Acme Packet 6300/6350 software.
Before rebooting the Acme Packet 6300/6350, save your configurations. The save-
config command is used to save the configuration in the example below.
For a full explanation and all options for the reboot command used in the example
below, refer to the ACLI Reference Guide.
To reboot the Acme Packet 6300/6350:
Chapter 6
Rebooting, Resetting, and Power Cycling
6-2
To Next Page
Loading...
Need help?
General
