Iked Synchronized disabled
TSCF Synchronized disabled
Active Peer Address 169.254.2.2
Redundancy Protocol Process (v3):
State Standby
Health 100
Lowest Local Address
169.254.1.1:9090
1 peer(s) on 2 socket(s):
system-1: v3, Active, health=100, max silence=1050
last received from 169.254.2.2 on wancom2:0
4. Confirm that SBC1 and SBC2’s current configurations match by typing display-
current-cfg-version and press Enter at the ACLI prompt.
NETNETSBC1# display-current-cfg-version
Current configuration version is 5
NETNETSBC1#
NETNETSBC2# display-current-cfg-version
Current configuration version is 5
NETNETSBC2#
Note:
While the two current configuration version numbers on the two systems
MUST match each other, they do not have to match the shared running
configuration version.
5. Confirm that the running configuration of SBC1 and SBC2 match by typing
display-running-cfg-version and pressing Enter at the ACLI prompt.
NETNETSBC1# display-running-cfg-version
Running configuration version is 5
NETNETSBC1#
NETNETSBC2# display-running-cfg-version
Running configuration version is 5
NETNETSBC2#
Note:
While the two running configuration version numbers on the two systems
MUST match each other, they do not have to match the shared current
configuration version.
Chapter 6
Standby Mode for HA Nodes
6-6
To Next Page
Loading...
Need help?
General
