Oracle Database Appliance X6-2-HA User Manual

Remove Disk Midplane Module HDD Cable
AppendixA • Servicing the Oracle Database Appliance Version 1 183
Remove Disk Midplane Module HDD Cable
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes removing the disk midplane module HDD cable from Oracle Database
Appliance Version 1.
1.
Prepare the system for service.
a.
Power off the system.
See “Shutting Down a Server Node and Powering Off the System” on page 109.
b.
Disconnect the power cords from the system.
c.
If the system is installed in a rack, remove it.
See the Oracle Database Appliance Owner's Guide for instructions.
d.
Attach an antistatic wrist strap.
See “Performing Electrostatic Discharge and Antistatic Prevention
Measures” on page 112.
2.
Remove the middle section of the system top cover.
See “Removing the Middle Section of the System Top Cover” on page 115.
3.
Disconnect the HDD ribbon cable connector located on the power distribution
board [1]).

Oracle Database Appliance X6-2-HA Specifications

General

Brand	Oracle
Model	Database Appliance X6-2-HA
Category	Storage
Language	English