Oracle Netra SPARC S7-2 Series User Manual

Reset the SP
Note - By default, the host automatically attempts to boot when the host is reset or
powered on. To learn about the parameters that control this action, see “Configuring Boot
Parameters” on page 43.
1.
Log in to Oracle ILOM.
See “Log In to Oracle ILOM” on page 19.
2.
Type one of these commands to reset the server.
■ Perform a graceful reset.
-> reset /System
■ If a graceful reset is not possible, perform a forced hardware reset.
-> reset -force /System
Related Information
■
“Power On the Server (Oracle ILOM CLI)” on page 26
■
“Power On the Server (Oracle ILOM Web Interface)” on page 27
■
“Reset the Server (Oracle Solaris)” on page 31
■
“Override OpenBoot Settings to Reset the Server” on page 53
Reset the SP
After the reset, your login session to the SP is terminated.
1.
Log in to Oracle ILOM.
See “Log In to Oracle ILOM” on page 19.
2.
Reset the SP.
-> reset /SP
Related Information
■
“Log In to Oracle ILOM” on page 19
32 SPARC and Netra SPARC S7-2 Series Servers Administration Guide • March 2017

Oracle Netra SPARC S7-2 Series Specifications

General

Brand	Oracle
Model	Netra SPARC S7-2 Series
Category	Server
Language	English