Oracle Netra SPARC S7-2 Series User Manual

Configure the Host Boot Mode (Oracle VM Server for SPARC)
The bootmode command is intended only to correct a problem with the OpenBoot or Oracle
VM Server for SPARC settings, so the new properties specified in this command take effect
for a single boot only. Additionally, to prevent an administrator from setting a bootmode state
property and forgetting about it, a bootmode state property expires if the host is not reset within
10 minutes of the bootmode state property being set.
Related Information
■
“Reset the Server (Oracle Solaris)” on page 31
■
“Reset the Server (Oracle ILOM)” on page 31
■
“OpenBoot Overview” on page 13
■
“Oracle VM Server for SPARC Overview” on page 14
Configure the Host Boot Mode (Oracle VM Server for
SPARC)
Note - You must use a valid Oracle VM Server for SPARC configuration name for this task.
1.
Log in to Oracle ILOM.
See “Log In to Oracle ILOM” on page 19.
2.
Determine the valid Oracle VM Server configurations on your SP.
-> show /HOST/domain/configs
3.
Set the boot mode configuration at the Oracle ILOM prompt.
-> set /HOST/bootmode config=configname
where configname is a valid named logical domain configuration.
For example, if you created a Oracle VM Server configuration called ldm-set1:
-> set /HOST/bootmode config=ldm-set1
To return the boot mode config to the factory default configuration, specify factory-default:
-> set /HOST/bootmode config=factory-default
4.
Power cycle or reset the server when you are ready to boot with the selected
configuration.
50 SPARC and Netra SPARC S7-2 Series Servers Administration Guide • March 2017

Oracle Netra SPARC S7-2 Series Specifications

General

Brand	Oracle
Model	Netra SPARC S7-2 Series
Category	Server
Language	English