Configuring SP and Host Network Addresses
These topics describe managing network addresses with Oracle ILOM.
■
“SP Network Address Options” on page 63
■
“Disable or Reenable Network Access to the SP” on page 64
■
“Display the SP Network Parameters” on page 64
■
“Display the Host MAC Address” on page 65
■
“Connecting to the SP (In-band)” on page 65
Related Information
■
“Matching Devices to Device Names” on page 69
SP Network Address Options
You can access the SP on your server in multiple ways. Consider the following options and
choose the access method that is best for your environment.
You can physically connect to the SP using a serial connection or a network connection.
The network connection can be configured to use a static IP address or DHCP (the default).
Optionally, the servers can use an in-band network connection to the SP, rather than the default
out-of-band NET MGT port.
For more information on each option, refer to this documentation:
■
To use a serial connection to the SP, refer to the information about connecting a terminal or
emulator to the SER MGT port in the installation guide for the server.
■
To assign a static IP address to the SP, refer to the information about assigning a static IP
address to the SP in the installation guide for the server.
■
To use an in-band connection to the SP, see “Oracle ILOM In-band (Sideband)
Management” on page 66.
Configuring SP and Host Network Addresses 63
To Next Page
Loading...
Need help?
General