Oracle Netra SPARC S7-2 Series User Manual

View All OpenBoot Parameters
Parameter Default Value Description
■
boot device-path – Boots from the device specified as device-path. See
“Locate Device Paths (OpenBoot)” on page 73.
boot-device disk net
Contains the name of the default boot device that is used when OpenBoot is not
in diagnostic mode.
boot-file
An optional parameter that provides boot arguments that are used when
OpenBoot is not in diagnostic mode.
diag-switch? false If the value is true, runs in the Diagnostic mode.
network-boot-arguments
An optional parameter that enables you to set configuration parameters to be
used by OpenBoot when you perform a WAN boot. Setting this parameter
takes precedence over any default boot parameter values. Refer to the
eeprom(1M) man page for details.
Related Information
■
“printenv Output” on page 48
printenv Output
This output is a sample from the OpenBoot command printenv on a SPARC S7-2 server. The
output for each server might be different.
{0} ok printenvVariable Name Value Default Value
ttya-rts-dtr-off false false
ttya-ignore-cd true true
keyboard-layout
reboot-command
security-mode none No default
security-password No default
security-#badlogins 0 No default
verbosity min min
diag-switch? false false
local-mac-address? true true
fcode-debug? false false
scsi-initiator-id 7 7
oem-logo No default
oem-logo? false false
oem-banner No default
oem-banner? false false
ansi-terminal? true true
screen-#columns 80 80
screen-#rows 34 34
48 SPARC and Netra SPARC S7-2 Series Servers Administration Guide • March 2017

Oracle Netra SPARC S7-2 Series Specifications

General

Brand	Oracle
Model	Netra SPARC S7-2 Series
Category	Server
Language	English